Fence Installation in Parker, CO

A fence does real work around a Colorado home: it adds privacy, keeps kids and dogs in, sets a clean edge on the yard, and shapes how the whole backyard feels. Mountain Ridge Renovations LLC installs and replaces fences for homeowners across Parker, Douglas County, and the south Denver metro — cedar privacy fences, picket and ranch-rail styles, gates, and custom privacy walls that tie into decks and outdoor living spaces.

Fences on the Front Range take a beating that fences in milder climates don't. Wind loads the panels, intense high-altitude UV dries and grays the wood, and the freeze-thaw cycle heaves any post that wasn't set deep enough. A fence that's built for those conditions — with posts set below the frost line in solid concrete and hardware that won't rust out — stays straight and square for years. One that's rushed starts leaning after the first hard winter. We build for the first outcome.

Layout, property lines, and utilities. We start by walking the line with you — where the fence runs, where gates go, and how it handles grade changes and low spots. Before anyone digs, underground utilities get located, and it's worth confirming your property line so the fence lands where it should. Getting this right up front avoids the two most expensive fence mistakes: building over the line, or hitting a utility.

Setting the posts. This is the part that decides everything. Posts are set in concrete footings below the local frost line so the freeze-thaw cycle can't heave them out of plumb — along the Front Range that depth is often around 30–36 inches, but we confirm the requirement locally. Post spacing and bracing are planned around your yard's wind exposure, because a solid privacy fence catches a lot of wind and the footings have to carry that load.

Panels, rails, and pickets. With posts set and cured, rails and pickets or panels go up square and level, following the grade cleanly instead of stair-stepping awkwardly. For privacy fences we pay attention to board spacing and gaps; for ranch and picket styles, consistent spacing is what makes the run look finished.

Gates and hardware. Gates are where a fence gets used every day, so they're built and hung to stay square and swing true, with hardware chosen to hold up outdoors. A sagging gate is the most common fence complaint, and it almost always traces back to how the gate posts were set.

Privacy walls and deck details. Beyond standard fencing, we build custom privacy walls that tie into decks and patios to screen a hot tub, a seating area, or a neighbor's sightline — the kind of work shown in our post on a privacy wall and fence upgrade in south Denver.

What it costs. As a general planning range, fencing typically runs about $25–$60 per linear foot in the Parker and south Denver market, depending mostly on material and height. Cedar privacy fence, picket, ranch rail, and metal all sit at different points in that range, and gates, hard digging, and grade changes add to it. These are planning figures, not a quote — the only accurate number comes from measuring your actual run on-site. For more on planning a fence, see our fence contractor guide for Parker, CO.

Permits, HOA, and setbacks. Many Parker neighborhoods have HOAs with architectural (ACC) review, so a new or replacement fence usually needs approval first — often with limits on height, material, and style — so it's worth starting that process early. Permit and setback rules vary by address; confirm with the Town of Parker or the Douglas County building division before setting posts.